|Complete Conversion of your Classic Porsche 911 or 912
Includes all parts and labor.
(Using the Standard Component Package)
Lightened Flywheel & High Performance Clutch
Also includes an Operator's Manual with all the
conversion component information, wiring
schematics, component placement diagrams,
EV4U Custom Conversions is a division and trademark of van Wyhe's
Custom Engraving and the sole property of van Wyhe's Custom Engraving,
and may not be used for any purpose or by anyone other than the owners.
EV4U does not share customer information with anyone. Components sold
by EV4U are waranteed by the individual manufacturers only.
|Copyright© 2019-2020 by VCE All rights reserved
|Ask about our
up to 240 HP !!
346 lb.-ft. of Torque
EV4U can provide all of the
components you need to convert
your VW to clean, efficient, quiet,
reliable electric power.
Plus EV4U offers assistance from
start to finish like no one else.
Contact EV4U today...
Additional Motor Options
88 HP & 108 lb.-ft. of Torque
Packages starting at $20,995
NetGain Hyper 9
120 HP & 173 lb.-ft. of Torque
Packages starting at $21,225
NetGain Hyper 9 HV
120 HP & 162 lb.-ft. of Torque
Packages starting at $22,225
HPEVS AC-50 X 2 Dual Motor Setup
152 HP & 2400 lb.-ft. of Torque
Packages starting at $27,995
HPEVS AC-51 X 2 Dual Motor Setup
176 HP & 216 lb.-ft. of Torque
Packages starting at $31,600
NetGain Hyper 9 X 2 Dual Motor Setup
240 HP & 346 lb.-ft. of Torque
Packages starting at $28,225
NetGain Hyper 9 HV X 2 Dual Motor Setup
240 HP & 324 lb.-ft. of Torque
Packages starting at $31,995
|We also convert
Porsche 914, 924, 944, & 928 models.
DIY Package Pricing
Includes components listed
under the Standard Package,
but with the below listed motor
DIY Standard Component Package
for the Porsche 911 or 912 includes
the following. $18,995
Approximately 60 mile range, 100 MPH top speed.
CALB CA Series Lithium Iron Phosphate Cells (44
- 100 Ah Cells) (14.6 kWh)
HPEVS AC-51 Three Phase AC Induction Motor
(88 HP, 108 lb.-ft. of torque)
Curtis 1239 Controller (500 amps)
Custom Controller Cooling System
ElCon 2.5 kW Charger
J1772 Charge Port (Level 2)
ElCon DC/DC Converter (30 amp)
Safety Interlock Relay
Service Disconnect Switch
JLD404 Intelligent Amp-hour Meter
Custom braided Interconnects
2/0 Cable (40') and Lugs
Fuse and Holder
Curtis 840 Display
Reverse Switch and Relay
Key Switch Relay
Economy Mode Switch
Reverse Light Relay
VDO 12 Volt Gauge
12 volt Fuse Block
12 volt Trickle Charger
If EV4U does the conversion, then you also get a
lightened flywheel, high performance clutch,
powder coat battery racks and an Operator's
Component specifications may change based on component availability.